Is Crypto Complete Ready for v7r3?

FAQs and general information.
Support_Rick
Posts: 3
Joined: 11/12/14 03:02:58 PM

Is Crypto Complete Ready for v7r3?

Postby Support_Rick » 01/15/15 04:25:49 PM

Q.

Does Crypto Complete run on version v7r3?

A.

Versions of Crypto Complete 1.21, and higher have been tested on V6R1, V7R1, V7R2 and V7R3 and there are no known issues.

Please note from V6.R1 and above, IBM introduced new commands SETMSTKEY and CLRMSTKEY in library QSYS. These commands are different than the ones in the CRYPTO Library. When using the SETMSTKEY in versions below 1.56, you will need to call the command from the command line and qualify the library (CRYPTO/ SETMSTKEY). When using the menus in Crypto Complete version 1.56 and above to use the command SETMSTKEY the correct command will be used.

When using the CLRMSTKEY command in versions below 2.50, you will need to call the command from the command line and qualify the library (CRYPTO/ CLRMSTKEY). When using the menus in Crypto Complete version 2.50 and above to use the command CLRMSTKEY the correct command will be used.

Return to “Crypto Complete”

Who is online

Users browsing this forum: No registered users and 1 guest

cron